![]() Oops, not header.txt, the empty file should just be named header with no extension. Hi, I am following your guide and have come across an issue with the plasma paths being produced on the wrong side of the profile to be cut. Can you suggest how this can be determined?ĭavid Try moving the orientation points to inside (or outside) of what you're trying to cut. I have a problem with a bmp (it´s only a comic figure with one black line). When i set the path to the gcode, i get one line outside the picture and one line inside the picture. But i want only one line(the same like the picture). ![]() When i paint a line with the pen, so it works, but not with the picture.ĭavid When you're tracing (vectorizing) the bitmap, you can try brightness cutoff instead of edge detection. You can also experiment with Inset, Outset, or Simplify under the path menu. Another option would be to just delete one of the vectors (either inside or outside the original line) and see if it looks close enough to the original image. Looks like it’s been awhile that anyone has posted. Not sure if this is being monitored anymore but I’ll try.
0 Comments
Leave a Reply. |